Home › Locations › San Rafael › Sub Panel Installation
Sub Panel Installation in San Rafael, NM
A sub panel gives you more breaker spaces and puts them where you actually need them. Our electricians install sub panels across San Rafael, with feeders sized for the load and the distance.
Sub panel work we do
Detached buildings are common around San Rafael, and each one needs its own properly grounded sub panel with a disconnect. We size the feeder for voltage drop on long runs, trench and install conduit where needed, and separate the neutrals and grounds the way the code requires.
- Sub panels for garages and workshops
- Power for casitas, guest houses, and additions
- Barn, well house, and outbuilding panels
- Underground and overhead feeders
- Load calculation to confirm the main can support it
- Grounding electrodes for detached structures
- Clear circuit labeling
- Permit and inspection
A sub panel makes sense when
- Your main panel has no open spaces
- You are adding a shop with welders, compressors, or a kiln
- You are building an addition or converting a garage
- A detached building needs more than one circuit
- You want an EV charger far from the main panel
Our process for sub panel installation in San Rafael
Reach us any time
Phones are answered around the clock. Urgent problems are sent to our emergency electrician.
On-site assessment
We find the real cause, not just the symptom, and lay out your options and their cost.
Repair or installation
You choose how to proceed, and we carry out the work carefully and safely.
Tested and explained
We test everything, label what we touched, and answer your questions before we go.
Local knowledge for San Rafael, Cibola County
Northwest New Mexico's plateau country brings freezing winter nights, spring wind, and summer lightning. Around San Rafael, that means voltage drop on long feeders, weathered outdoor equipment, and electrical systems that have been added onto over the years.
Depending on your address, power in Cibola County typically comes from Continental Divide Electric Cooperative. When a job involves the meter or the service connection, we coordinate the shutoff and reconnection with the utility.
We provide sub panel installation throughout San Rafael and in nearby Cubero, Milan, San Fidel, and Grants.
More electrical services in San Rafael
Sub panel installation near San Rafael
- Cubero sub panel installation
- Milan sub panel installation
- San Fidel sub panel installation
- Grants sub panel installation
- Bluewater sub panel installation
- Prewitt sub panel installation
Statewide details: Sub Panel Installation in New Mexico.
Sub Panel Installation FAQs for San Rafael
Sub panel or full panel upgrade: which do I need in San Rafael?
If the main service has enough capacity and you only need more spaces or power in a new location, a sub panel is usually enough. If the service itself is too small, you need a panel upgrade. We run the numbers and tell you which.
How big should a sub panel be?
A garage or small shop commonly uses 60 to 100 amps. A casita with its own cooking and cooling may need more. We size it to what you plan to run.
Can you run power to a detached building?
Yes. We trench, lay conduit, pull the feeder, and install the panel and grounding at the building.
Which areas around San Rafael do you cover for sub panel installation?
All of San Rafael and the surrounding Cibola County communities, including Cubero, Milan, and San Fidel.
Related reading: How Much Does an Electrical Panel Upgrade Cost in New Mexico?
Need sub panel installation in San Rafael?
Call any time. We answer 24 hours a day.