Sub panel work we do
Detached buildings are common around Miami, and each one needs its own properly grounded sub panel with a disconnect. We size the feeder for voltage drop on long runs, trench and install conduit where needed, and separate the neutrals and grounds the way the code requires.
- Sub panels for garages and workshops
- Power for casitas, guest houses, and additions
- Barn, well house, and outbuilding panels
- Underground and overhead feeders
- Load calculation to confirm the main can support it
- Grounding electrodes for detached structures
- Clear circuit labeling
- Permit and inspection
A sub panel makes sense when
- Your main panel has no open spaces
- You are adding a shop with welders, compressors, or a kiln
- You are building an addition or converting a garage
- A detached building needs more than one circuit
- You want an EV charger far from the main panel
Our process for sub panel installation in Miami
Tell us about the job
Call any time and describe what you need. We schedule the visit around your day.
Get a clear price
We look at the work on site and give you a written price before anything starts.
Work done properly
Our electricians complete the job to the New Mexico Electrical Code, with inspections where a permit is required.
Final walkthrough
We show you what was done, test it with you, and leave your home or business tidy.
Local knowledge for Miami, Colfax County
At elevation, Miami sees cold winters, heavy snow on service lines, and lightning in the summer. Space heaters, heat tape, and well pumps work hard here, and many older homes were wired long before those loads existed.
Depending on your address, power in Colfax County typically comes from your local utility or rural electric cooperative. When a job involves the meter or the service connection, we coordinate the shutoff and reconnection with the utility.
Call us for sub panel installation anywhere in Miami, or in nearby Springer, Cimarron, Ocate, and Ojo Feliz.
More electrical services in Miami
Sub Panel Installation FAQs for Miami
Sub panel or full panel upgrade: which do I need in Miami?
If the main service has enough capacity and you only need more spaces or power in a new location, a sub panel is usually enough. If the service itself is too small, you need a panel upgrade. We run the numbers and tell you which.
How big should a sub panel be?
A garage or small shop commonly uses 60 to 100 amps. A casita with its own cooking and cooling may need more. We size it to what you plan to run.
Can you run power to a detached building?
Yes. We trench, lay conduit, pull the feeder, and install the panel and grounding at the building.
Which areas around Miami do you cover for sub panel installation?
All of Miami and the surrounding Colfax County communities, including Springer, Cimarron, and Ocate.
Related reading: How Much Does an Electrical Panel Upgrade Cost in New Mexico?
Need sub panel installation in Miami?
Call any time. We answer 24 hours a day.