Sub panel work we do
Detached buildings are common around Capulin, and each one needs its own properly grounded sub panel with a disconnect. We size the feeder for voltage drop on long runs, trench and install conduit where needed, and separate the neutrals and grounds the way the code requires.
- Sub panels for garages and workshops
- Power for casitas, guest houses, and additions
- Barn, well house, and outbuilding panels
- Underground and overhead feeders
- Load calculation to confirm the main can support it
- Grounding electrodes for detached structures
- Clear circuit labeling
- Permit and inspection
A sub panel makes sense when
- Your main panel has no open spaces
- You are adding a shop with welders, compressors, or a kiln
- You are building an addition or converting a garage
- A detached building needs more than one circuit
- You want an EV charger far from the main panel
What happens when you call about sub panel installation
Reach us any time
Phones are answered around the clock. Urgent problems are sent to our emergency electrician.
On-site assessment
We find the real cause, not just the symptom, and lay out your options and their cost.
Repair or installation
You choose how to proceed, and we carry out the work carefully and safely.
Tested and explained
We test everything, label what we touched, and answer your questions before we go.
Sub Panel Installation for Capulin homes and businesses
On the plains of eastern New Mexico, electrical systems around Capulin serve homes, agricultural operations, and industry alike. Long overhead lines, high winds, and severe thunderstorms make surge protection and solid service connections especially important.
Depending on your address, power in Union County typically comes from your local utility or rural electric cooperative. When a job involves the meter or the service connection, we coordinate the shutoff and reconnection with the utility.
Our sub panel installation covers all of Capulin, along with neighboring Des Moines, Folsom, Raton, and Gladstone.
More electrical services in Capulin
Sub panel installation near Capulin
- Des Moines sub panel installation
- Folsom sub panel installation
- Raton sub panel installation
- Gladstone sub panel installation
- Grenville sub panel installation
- Maxwell sub panel installation
Statewide details: Sub Panel Installation in New Mexico.
Sub Panel Installation FAQs for Capulin
Sub panel or full panel upgrade: which do I need in Capulin?
If the main service has enough capacity and you only need more spaces or power in a new location, a sub panel is usually enough. If the service itself is too small, you need a panel upgrade. We run the numbers and tell you which.
How big should a sub panel be?
A garage or small shop commonly uses 60 to 100 amps. A casita with its own cooking and cooling may need more. We size it to what you plan to run.
Can you run power to a detached building?
Yes. We trench, lay conduit, pull the feeder, and install the panel and grounding at the building.
Which areas around Capulin do you cover for sub panel installation?
All of Capulin and the surrounding Union County communities, including Des Moines, Folsom, and Raton.
Related reading: How Much Does an Electrical Panel Upgrade Cost in New Mexico?
Need sub panel installation in Capulin?
Call any time. We answer 24 hours a day.