Dedicated Circuit Installation in Corona, NM

Circuits we install

A common request in Corona is a 240 volt circuit for refrigerated air when a home converts from an evaporative cooler. Others include circuits for EV chargers, mini-splits, electric ranges, and garage tools. We size the wire and breaker to the equipment's nameplate.

• Air conditioner, heat pump, and mini-split circuits
• Electric range, cooktop, and wall oven circuits
• Dryer and washer circuits
• Microwave, dishwasher, and disposal circuits
• Freezer and second refrigerator circuits
• Welder, compressor, and table saw circuits
• Well pump and water heater circuits
• Home office and server circuits

You probably need a dedicated circuit if

• A breaker trips when two appliances run together
• You are installing refrigerated air or a mini-split
• An appliance manual calls for its own circuit
• You rely on extension cords or power strips for big loads
• Lights dim when a motor starts

Local knowledge for Corona, Lincoln County

In the high country around Corona, electrical systems have to handle freezing winters, summer thunderstorms, and long rural service runs. Thick adobe walls and historic construction make wiring work slower and call for careful planning.

Electric service in Lincoln County is typically provided by PNM or Otero County Electric Cooperative. For work on the service entrance or meter, we arrange the disconnect and reconnect with them so you do not have to.

We provide dedicated circuit installation throughout Corona and in nearby Cedarvale, Claunch, Encino, and Vaughn.